Page 1 of 1
Query! Need suggestions
Posted: Fri Jul 20, 2007 12:35 pm
by Mustang
What do you do in case the floor board is damaged. Can you fix a new one or do you have to only weld a new piece??
Muroor did not pass bcos of this!
Posted: Fri Jul 20, 2007 1:45 pm
by iguana
What do you mean by the floor board? is it the metal sheets under the car or under the seats >>> if this is teh case, you can weld new ones ... If you are talking about the chasis then forget it, the car is gone and will never pass muroor
Give Doc a call, he can check the car up and fix it
Posted: Fri Jul 20, 2007 4:50 pm
by Mustang
I meant the metal sheets under the car! The chassis is fine
What is Doc's number by the way?
Posted: Fri Jul 20, 2007 10:41 pm
by H3
I would have thought assuming you are talking about dents in the floor you could locate them from inside the car and knock them back out again. Depends where they are, you might have to remove a seat or something to get at the dent but it is possible providing the dents are not in a place thats double skinned i.e. on a monocoque type chassis but a typical body on chassis type vehicle are usually single skinned in which case it is repairable as described above.
Posted: Fri Jul 20, 2007 11:42 pm
by iguana
Doc's number is 050 6526707 His name is Richard
Re: Query! Need suggestions
Posted: Thu Jul 26, 2007 4:52 pm
by Chuck
Mustang wrote:What do you do in case the floor board is damaged. Can you fix a new one or do you have to only weld a new piece??
Muroor did not pass bcos of this!
What car do you drive ?
Posted: Thu Jul 26, 2007 10:23 pm
by Mustang
2006 Land Cruiser GXR
Getting a '94 Cherokee fixed